- Features
- Specifications
- Dimensions
- Whats in the box
- Factory-matched stereo pair of T2 large-diaphragm condenser microphones
- Hand-crafted 1-inch titanium-sputtered true condenser capsule
- Four selectable polar patterns: Cardioid, Hypercardioid, Omnidirectional, and Figure-8
- Fast transient response for detailed capture of drums, percussion, and other sources with strong attack
- Switchable 40 Hz and 80 Hz low-cut filters
- Switchable -10 dB and -20 dB attenuation pads
- Roadworthy die-cast all-metal housing with metal switches
- Rugged spring-steel wire mesh grille
- Custom shockmount design for close-miking applications
- Suitable for vocals, drums, percussion, guitars, piano, strings, and other studio or live applications
| Specification | Detail |
|---|---|
| Microphone Type | Large-Diaphragm True Condenser |
| Capsule | Hand-crafted 1" True Condenser |
| Diaphragm | Titanium-sputtered Mylar |
| Polar Patterns | Cardioid / Hypercardioid / Omnidirectional / Figure-8 |
| Frequency Response | 20 Hz – 20 kHz |
| Sensitivity | 25 mV/Pa (-32 dBV) |
| Maximum SPL | 137 / 147 / 157 dB SPL (0 / 10 / 20 dB attenuation pad, 0.5% THD) |
| Equivalent Noise Level | 13 dB(A) |
| Signal-to-Noise Ratio | 81 dB |
| Low-Cut Filter | 40 / 80 Hz, 6 dB/octave, switchable |
| Attenuation Pad | 10 / 20 dB, switchable |
| Electrical Impedance | 22 Ohms |
| Power Requirement | 48 V Phantom Power according to IEC 61938 |
| Connector | 3-pin Male XLR |
| Microphone Length | 146 mm |
| Microphone Width | 58 mm |
| Microphone Diameter | 29 mm |
| Microphone Weight | 290 g each |
Boxed dimensions: Not officially specified by sE Electronics.
- 2 × T2 microphones
- 2 × Custom shockmounts with thread adapters
- 1 × Stereo mounting bar
- 1 × Metal microphone case
Hand-Crafted Titanium Capsule and Precision Internal Engineering
A cutaway view reveals the sE T2’s custom titanium-sputtered capsule mounted directly above high-grade, low-noise circuit componentry. Titanium’s ultra-lightweight and rigid structure delivers lightning-fast transient response, while integrated body switches allow instant access to attenuation pads (-10dB/-20dB) and low-cut filters right on the die-cast metal housing.
Flat-Chassis Form Factor for Precision Guitar Amp & Instrument Miking
The T2’s sleek, ultra-flat design and custom shockmount allow it to fit into extremely tight recording spaces. Whether flush-mounted directly in front of a loud guitar amplifier cabinet, tucked inside a kick drum, or placed over snare rims, its low-profile footprint ensures exact mic positioning without mechanical obstruction.
Factory-Matched Pair Package in Heavy-Duty Aluminum Flight Case
Built for critical stereo recording and touring, the sE T2 Factory-Matched Pair arrives complete inside a rugged aluminum flight case with dense protective foam cutouts. The complete system includes two sonically matched T2 microphones, two custom shockmounts, and a precision stereo mounting bar for effortless ORTF, XY, or Blumlein array setups.
